The Vogue Fringe Belt is made from a scrap bicycle tire and inner tubes - a resourceful and eco-friendly alternative to leather. Due to the nature of working with up-cycled materials and the creative process - no two Laura Zabo pieces are ever the same. Each piece is unique, like you.

The Vogue Fringe Belt is made from 60+ individually cut and crafted tassels that vary in length from 40cm to 80cm and stunning inner tube leaves.

This beautiful piece is perfect for dressier occasions or festival season. Laura Zabo pieces are made for the urban warrior who wants to stand out be different and make a positive impact on the planet at the same time. Wear your Vogue Fringe Belt with a stretchy dress or hot short - and take your outfit from basic to chic in a flash.

The full lenght is 80 cm.

SIZES

SMALL : 27"-29" 69-74cm
MEDIUM : 30"-32" 76-81cm
LARGE : 33"-35" 84-89cm
VERY IMPORTANT INFORMATION

Typically, belts are measured from the edge of the buckle to the middle hole. This measurement does not usually include the buckle itself. Because belts go around your pants, not just around your waist, a properly fitting belt will usually be a little larger than your waist size or pants size.

If you already have a belt that fits but aren't sure what size it is, you can measure it to determine your belt size. Do not measure the belt from end to end. Lay the belt out flat and measure from where the buckle attaches to the belt (do not include the buckle itself in your measurement) to the hole that you normally use. Choose the belt size that most closely matches this number for a perfect fit.

One way to determine which belt size to choose is to buy a belt that is one to two inches larger than your current pants size. For example, if you wear a size 34 pants, you could order a size 36 belt.

If you are in-between sizes and require a customised size, please specify the exact length you would like your belt to be, including the buckle. Please note that jeans sizes are generally smaller and should not be used as an accurate measurement.
Please specify the position you would like the first (tightest) hole and the last (loosest) hole. If you have a current belt you are happy with, please measure that and supply us with the information on length and hole positions.